For our correct pump selection and quotation, our enginneer normally need below operating data:
The general |
Project name (if any) | |
Project location (country name) | |
Pump purpose (transfer,loading,process...) | |
Pumping fluid |
Fluid name | |
Fluid temperature（℃） | |
Fluid Viscosity（cSt） | |
Fluid density | |
Corrosion/solid content (if any) | |
Operating conditions |
Flow rated (m3/h) | |
Pump suction pressure (bar) | |
Pump discharge pressure (bar) | |
Installation place (indoor or outdoor) | |
Installation ambient temperature (℃) | |
Electric motor |
Electricity frequency (50Hz,60Hz...) | |
Electricity voltage (380v,400v,6kv...) | |
Motor protection grade (IP54,IP55,IP65...) | |
Explosion proof type or not | |
Application field ( use√to mark) |
Oil & gas | Tank farm & terminal |
Marine & Offshore | Chemical |
Power plant | Steel plant |
Petrochemical | Other |
Supply scope ( use√to mark) |
Bare-shaft pump only |
|
Whole pump unit including motor | |
Other requirement (if any) |
1. |
2. |